Tutorial - Witch Hat free standing lace embroidery design, FSL

If you are new to stitching free standing lace embroidery, here is a tutorial. It is easy and not complicated. The machine embroidery design of Witch Hat you'll find here: Witch Lace Hat with a Spider - embroidery design.


Details

For hoop 4x4, require 2 hoopings

 

Important!

Make your embroidering on water soluble stabilizer (wash away stabilizer). Use Stabilizer for free-hand embroidery, lace or any project that requires the complete removal of the stabilizer. 

Wash-away stabilizers completely dissolve in cold or warm water, without leaving a sticky residue or stiff fabric.


Steps:

    1. Hoop stabilizer only

    2. Stitch design directly on stabilizer    

    3. Unhoop and trim excess stabilizer

    4. Rinse with water remaining stabilizer

    5. Dry completely

    6. Unhoop and sew by hands, if needed 

        YOU ARE DONE!

Assembly

Use the same embroidery thread in bobbin. 

Take the upper detail, fold it.

And sew the center seam, using stitch type over the edge.

Witch hat cone ready.

Take the circle piece,  it is hat bottom part.

 Matching hat middle detail seam with center of back bottom detail.

Stitch along this edge. While you are stitching, pull and manipulate the pieces so they are nicely together.


Complete this seam and you are ready with witch hat.

Please feel free ask questions. 

info@artapli.com


 Other FSL designs from Artapli

All FSL details designs are pre-combined, just stitch, rinse, dry and sew on!